天津福仕德動力技術有限公司從事于當代新型電磁離合器電磁多片離合器與制動器、牙嵌式電磁離合器與制動器、單片式電磁離合器與制動器以及電磁失電離合器與制動器的研究與生產。1 制動鉗體缸筒不得有銹蝕、損傷現象，否則必需更換。制動鉗體缸簡圓柱度誤差應不大于0.02mm，缸筒與活塞的極限配合間隙應小于0.15 mm，不得用研磨的方法修理缸筒。1 brake caliper body cylinder must not have rust, damage phenomenon, otherwise required replacement. Brake caliper body cylinder Jane cylindricity error shall not be more than 0.02 mm, cylinder piston and limit fitting clearance should be less than 0.15 mm, not use grinding method of repair cylinder.2 沿活塞邊沿不應有液體滲漏，必需保證密封圈、防尖罩的完好，否則應更換密封圈、防塵罩或活塞。密封圈必需保持良好的機能。2 the piston edge of liquids, should not have necessary guarantee sealing ring, prevent pointed cover intact, or should be replaced to seal, dust-proof covers or piston. Sealing ring must maintain good function.3 活塞表面不得有劃痕、裂紋、凹坑、侵蝕和麻點，否則應更換活塞，不得使用打磨、擦刮、拋光的方法修理有劃痕的活塞。3 the piston surface must not have Nick, crack, indentation, erosion and hemp dot, or should be replaceable piston, shall not use the burnish, wipe scraping, polishing method of repair have Nick piston.4 浮鉗盤式制動器導向裝置的配合面應光潔完好。防護套不應有切傷和彼裂，否則應更換防護套。4 float caliper disc brake orientation device with surface should be smooth intact. Protective set should not have cut wounds and Pilate crack, or should be replaced protection sets.5制動鉗安裝架（對于浮鉗盤式制動器）不得有裂紋和嚴峻磨損，支承彈簧應機能完好，制動塊支承板不應有損傷。5 brake caliper mounts (for floating caliper disc brake) must not crack and severe wear, supporting spring should function intact, brake pads plate should not damage. 天津福仕德動力技術有限公司聯系人：李經理手機：13820305912電話：022-24051292 022-87897365傳真：022-87897365地址：天津市南開區科研西路16號郵箱：442543693@qq.com